It's no longer a story that almost all the MTK devices from August 2022 security have been updated to block preloader, which leads to Brom jump error and of course, prevents the device from being flashed with any box or dongle.
In today's post, I'll be proving the Brom solution for Tecno Spark 9T KH6 which will allow the device to be flashed with Cm2 dongle without any Error tested solution
The below image portrays the error you'll get if Brom blocked
To overcome the trouble you need to lay your hands on the Brom Jump solution. with the solution, you'll be able to flash the device with any flashing box or dongle of your choice.
Logs
BROM ERROR
BROM: BROM BL: 0xFF 0x03
BROM: PRELOADER PORT
AGENT:0_base:BASE_v2112 | Manual: Disabled
AGENT: Look for suitable BootChain in DA...
AGENT:MTK_AllInOne_DA.bin
AGENT: Found MT6761
AGENT: MTK_DOWNLOAD_AGENT
BROM: Sending 1st DA...
BROM: 0x00007024: DA SEND ERROR!
ERROR: SECURE BOOT: SELECTED DA IS NOT SUPPORTED IN THE CURRENT DEVICE STATE!
INFO: PRELOADER Level: CORRECT DA required: PL/PL_CRYPTO/SWSEC
Error: Fail to init protocol
>>> Remove battery, cable. Check cable/connection/driver! Check SW hint! Repeat operation! Reconnect Power/Cable!
In this post am going to provide the solution to bypass the Brom Jump solution for Tecno Spark 9T KH6 but NOT FREE OF CHARGE.
My solution is already tested and 100% working so you have nothing to worry about.
PROOF OF THE SOLUTION BEFORE AND AFTER
BEFORE SOLUTION |
AFTER THE SOLUTION |
File information
After purchasing the solution, you'll have access to the pack including the steps to do it
File Name: Tecno Kh6 Brom Jump solution
File Size: 2MB
Status: Paid Solution
PLEASE CONTACT ONLY WHEN YOU'RE READY TO PAY